FAQ: How To Make Wood Table With Resin Inlay?

How do you make an epoxy inlay table?

How to create dramatic inlays with epoxy

  1. Rout the grooves. Because the epoxy is translucent, the grooves must be cut cleanly without burning, so use a sharp bit in the router.
  2. Build a dam.
  3. Mix the two parts.
  4. Tint and fill.
  5. Overfill the grooves.
  6. Pull off the caulk.
  7. Sand it.
  8. Rough out the shape.

Can you make a table with resin?

The idea and the trend of the so-called Epoxy River Tables come from the USA like so many others. In the last years, a real epoxy resin table fever has broken out all over the world, of course also in Brazil. Because these tables are very modern but at the same time also extremely noble and high-quality.

Can you route resin?

Once resin is cured, you can machine it, meaning you can cut it and drill it with power tools without concern. The resin will cut cleanly at a perfect 90 degrees and you will be able to see a lovely cross-section side of the resin. The wood will be showing as the finished edge, or you can paint it as desired.

What type of wood is used for resin?

The best material to use for an epoxy resin table is typically the flattest piece of live edge wood you can find – such as Yew, Elm, Oak or Black Walnut – that has been properly air dried so the moisture level is below 20%.

You might be interested:  Quick Answer: Does Cricut Maker Cut Wood?

How do you seal wood before epoxy?

Before applying epoxy, sand smooth non-porous surfaces —thoroughly abrade the surface. 80-grit aluminum oxide paper will provide a good texture for the epoxy to “key” into. Be sure the surface to be bonded is solid. Remove any flaking, chalking, blistering, or old coating before sanding.

What does resin not stick to?

Here are a few well-known materials that epoxy resin doesn’t stick to: Parchment or Wax Paper. Sheathing or Tuck Tape. Silicone, Vinyl or Rubber.

How do you make a resin table at home?

Create your own Epoxy River Table – step-by-step instructions

  1. Step 1: Removing the bark and sanding the wood.
  2. Step 2: Fill in bumps and cracks and seal the wood.
  3. Step 3: Build a mould / formwork for the table top.
  4. Step 4: Inserting the wood into the mould.
  5. Step 5: Mix epoxy resin.

How much resin do I need for a table?

Most common table top and bar top epoxies provide approximately 12 sq feet per mixed gallon coverage at 1/8″ thickness.

Leave a Reply

Your email address will not be published. Required fields are marked *